Used for more complex split molds where the taper must go in two directions from a specific line.
Below are the most likely ways to "draft a solid feature" depending on which software you are using. 1. In 3D Modeling (SOLIDWORKS / CAD)
When creating a "Solid Boss/Extrude," you can enable the Draft icon directly in the PropertyManager to add an angle while the solid is being created.
The most common method. Select a "Neutral Plane" (the fixed face) and then select the faces you want to taper.
SAVE UP TO 67% OFF
7382zip <2024>
Used for more complex split molds where the taper must go in two directions from a specific line.
Below are the most likely ways to "draft a solid feature" depending on which software you are using. 1. In 3D Modeling (SOLIDWORKS / CAD)
When creating a "Solid Boss/Extrude," you can enable the Draft icon directly in the PropertyManager to add an angle while the solid is being created.
The most common method. Select a "Neutral Plane" (the fixed face) and then select the faces you want to taper.